Can-Am 3D-printed cargo rack anchor M8 – 8psc

Can-Am cargo rack anchor M8 thread

Quanity – 8psc

Fits all Can-Am ATVs with LinQ system holes in the luggage rack

Creates a threaded hole on the ATV luggage rack where you can attach various accessories or a load securing eyelet for creating tie down anchor point.

Material: 3D printed abs, bolts and nuts galvanized steel

To install, turn the eccentric nuts away from the mounting anchor so that there is a gap of about 3mm between the nuts and the anchor

Rotate the eccentric nuts under the anchor and place the anchor to LinQ hole.

When tightening the bolts, the eccentric nuts are rotating themselves from under the anchor and the fixing anchor into place. The optimal tightening torque for the bolts is approximately 2.5-3 Nm. Do not overtighten!

To remove the anchors, unscrew the mounting bolts 3-4 turns counterclockwise. The eccentric nuts will rotate themselves under the anchor and you can pull the anchor out of the hole.

Warning!!! 3D printed anchor is not as strong as aluminum anchor. Do not use 3D printed anchors to attach heavy or critical accessories!!!

3D printed anchor may break under excessive load!!!

Designed and manufactured in Estonia